6 Mounting
SMA Solar Technology AG
Installation Manual 15SCCPXT-SCS_NR-IA-en-12
Requirement:
☐ The additionally required mounting material must be available (see Section5.1, page13).
Procedure:
1.
DANGER
Danger to life from electric shock due to live voltage
Prior to performing any work on the inverter, disconnect it from voltage sources (see inverter installation
manual).
2. Loosen the four screws of the left front kick plate (TX 30). Retain
the screws for subsequent mounting of the new kick plates.
3. Remove the front kick plate.
4. Loosen the four screws of the right rear kick plate (TX 30). Retain
the screws for subsequent mounting of the new kick plates.
5. Remove the rear kick plate.
6. Dispose of the kick plates in accordance with the locally applicable disposal regulations.
6.3 Removing the Existing Ventilation Plate
1. Pull the ventilation plate forwards out of the base area of the
inverter cabinet. Grip underneath the ventilation plate and press
the middle part up while pulling it out.
2. Dispose of the ventilation plate.
To Next Page
Loading...
