6 Mounting
SMA Solar Technology AG
Installation Manual 17SCCPXT-SCS_NR-IA-en-12
3. Unscrew all ten screws of the rear panel using a suitable
screwdriver (TX 30).
4. Remove all screws from the rear panel and retain for later use.
5. Carefully pull the rear panel of the inverter cabinet approx.
80mm to 100mm towards you. Make sure that the hook fitting
cannot fall out.
6.
NOTICE
Property damage due to grounding cable being ripped out
The rear panel of the inverter and the switch cabinet are connected via a grounding cable. If the rear panel is
removed without due care, the grounding cable could be ripped off and the inverter damaged.
• Use a wrench to release the grounding cable from the
rear panel before removing the rear panel (AF 13).
7. Remove the rear panel and store it.
To Next Page
Loading...
