Dipped-beam headlamps
X
To switch on: turn combination switch
control : until L is at marking ;.
The L indicator lamp in the instru-
ment cluster lights up.
Side lamps
X
To switch on: turn combination switch
control : until T is at marking ;.
Foglamps
Only vehicles with front foglamps have the
"Foglamps" function.
X
To switch on: make sure that the side
lamps or dipped-beam headlamps are
switched on.
X
Turn combination switch middle ring E
until marking D is at N.
The N indicator lamp in the instru-
ment cluster lights up.
After
releasing,
the middle ring returns
automatically back to the neutral posi-
tion.
X
To switch off: turn combination switch
middle ring E until marking D is at
N.
The N indicator lamp in the instru-
ment cluster goes out.
After
releasing,
the middle ring returns
automatically back to the neutral posi-
tion.
i
If you
switch off the engine (only in the
à position) or turn off the lights, the
foglamps are also switched off.
Rear foglamp
X
To switch on: make sure that the side
lamps or dipped-beam headlamps are
switched on.
X
Turn combination switch middle ring E
until marking D is at R.
The R indicator lamp in the instru-
ment cluster lights up.
After
releasing,
the middle ring returns
automatically back to the neutral posi-
tion.
X
To switch off: turn combination switch
middle ring E until marking D is at
R.
The R indicator lamp in the instru-
ment cluster goes out.
After
releasing,
the middle ring returns
automatically back to the neutral posi-
tion.
i
If you
switch off the engine (only in the
à position) or turn off the lights, the
rear foglamps are also switched off.
Adjusting the headlamp range
The headlamp range control allows you to
adjust the
cone of light from the headlamps
to suit the vehicle load. The cone of light
changes when seats are occupied or when
the luggage compartment is loaded or
unloaded. This can impair visibility and
dazzle oncoming traffic.
88
Exterior lighting
>> Lights and windscreen wipers.
To Next Page
Loading...
Need help?
General
