SmarTap e-Valve - Page 23

21 of 51
SP and PEX pipe
1. Insert G
1
2
⁄ BSP male connectors into all unit inlets and outlets (x 5).
2. Proceed to installation procedure.
Copper pipes
1. Weld a copper pipe to a male fitting.
WARNING
IT IS FORBIDDEN TO WELD DIRECTLY NEXT TO THE
UNIT. MINIMUM DISTANCE FROM E-VALVE BODY IS
15CM. USE WETTED RAG TO PREVENT UNIT FROM
RECEIVING DIRECT HEAT FROM THE WELDING
TORCH
2. Connect the male fitting to the e-Valve terminals.