22 of 51
Prepare Infrastructure
Prepare the Hot and Cold water inlet pipes.
Run the outlet applicable pipes from the e-Valve unit to the outlet.
MARK ON EACH PIPE ITS DESIGNATION.
MAKE SURE THAT THE PIPEWORK IS
PERPENDICULAR TO THE E-VALVE SO THAT THERE IS
NO STRAIN ON THE FITTINGS.
Prepare the mounting location
according to the Two Dial
controller junction box
dimensions.
Prepare the mounting location
according to the One Dial
controller junction box
dimensions.
FOR DRY-WALL INSTALLAITON, CUT THE WIDTH
AND HEIGHT DIMENSIONS IN THE WALL.
Prepare the Two Dial
controller mounting position
Prepare the One Dial
controller mounting position
(If applicable)
To Next Page
Loading...