Run the Two Dial control cable from the location of the e-Valve unit
to the location of the Two Dial controller – female end on e-Valve
side , male end on controller side
Use 20mm Electrical conduits.
Leave Extra cable at the e-Valve side.
Run the One Dial control cable from the location of the Two Dial
controller to the location of the One Dial controller - female end on
Two Dial controller side. Male end on One Dial controller side.
Use 20mm Electrical conduits.
Leave extra cable inside the conduit.
Run Two Dial control cable
Run One Dial control cable (If applicable)
To Next Page
Loading...