SmarTap e-Valve - Install Power Supply

37 of 51
Install Power Supply
Vertical installation
1. Hold the power supply up to the installation location:
a. Make sure that the AC cord will reach the electrical outlet.
b. Make sure that the DC cord will reach the e-Valve DC cable inlet.
CAUTION
MAKE SURE THAT YOU HAVE ENOUGH SPARE CABLE
FOR MAKING DRIP LOOPS ON BOTH ENDS.
2. Mark the hole locations.
3. Secure the power supply with the screws to the wall.
CAUTION
DO NOT PLUG THE POWER SUPPLY INTO THE
ELECTRICAL OUTLET AT THIS TIME.
Power supply installation