ICON Lamp Dimmer User’s Guide
Page 11 of 18
Enabling X10 Resume Dim
If X10 Resume Dim is enabled, ICON Lamp Dimmer will remember the last brightness level to which it
was set. Then, when an X10 ON command is received from an X10 Controller, the lamp will go to the
remembered brightness, rather than to the X10 On-Level.
To enable X10 Resume Dim, set up an X10 Primary Address On-Level of OFF (or zero). To disable X10
Resume Dim, set up an X10 Primary Address On-Level of anything but OFF.
See the section Setting the X10 On-Level for the X10 Primary Address, above, for instructions (briefly, set
the brightness, then tap the SET Button).
To Next Page
Loading...
