Maintenance and servicing
Integrated immersing UV-C
Instruction manual EBF / EBF ECO page 14 of 19
11/2014
highly recommended for all Pumped models!
If the overflow protection system has not been installed, the manufacturer
will reject any claims for damage arising through pumping out/dry of the
pond.
5.2 Integrated immersing UV-C
The Smartpond® immersing UV-C can directly integrated in the filter. For
this purpose, a UV-C belt protection plate shall be built in since otherwise,
the filter belt may be damaged by the UV-C rays.
The Smartpond® immersing UV-C is connected at the control unit box.
The filter can optionally be equipped with a UV-C switch-off feature.
Through this, the immersing UV-C will automatically switch off on
removal of the protective cover.
If the additional option “UV-C disconnection’’ has not been selected and
the filter is accessible to third parties, the owner of the plant shall ensure
that adequate safety measures are in place on-site in order to rule out
the possibility of UV-C irradiation.
Never lay down the immersion UV-C on the filter belt. It shall only be
placed in the UV-C holder specifically designed for it. The material can get
damaged through UV-C exposure!
6 Maintenance and servicing
6.1 Cleaning of filter belt
Depending on the degree of contamination, the throughput volume on
the filter belt may be reduced after some time or the rinsing water
consumption may be increased since a bio-film or lime deposit forms up
on the filter belt.
A narrow strip of dirt may be formed on the filter belt in the direction of
movement due to blocking of a belt spraying nozzle. In this case, the
nozzle has to be cleaned (see 6.5 Cleaning of belt spraying nozzle).
The filter belt can be sprayed and washed up with the following
detergents according to the manufacturer:
Here is an overview of the resistance of the polyester filter belt fabric to various detergents (details provided
by the manufacturer):
To Next Page
Loading...