MY SETTINGSMY SYNERGY
MON 13:15
MY SYNERGY
Room Temperature 19˚C
Air Source Outside
Fan Speed High
MY SYNERGYSYSTEM SETTINGS
15 MAR
13:15
SmartVent
10
RESET
When Synergy is first installed, the
operating system defaults to set
conditions. Most importantly, the
in-line tempering heater (if installed) is
disabled.
The following is the status of Synergy
when Reset or when first installed:
f Minimum temperature: 18ºC
f Comfort Level: Mid Range (indicated
by green bar):
f Clock*: 00:00 (Hr:Min)
f Fan Speed: High
f Heater: Disabled (if installed)
f Speaker Volume: Level 4 (medium)
f Contrast: Level 5 (medium)
f Brightness: Level 5 (medium)
f Automatic Boost Fan: Enabled
f Fan Min: Enabled-Low
f Fan Seasons: Disabled
* A system RESET will not reset the Clock to
zero, this only occurs when first installed.
Synergy can be RESET at any time. This
procedure enables you to restore the
system to the known values above BUT
all customised settings will be lost as a
result of this action.
Note:
The filter usage total is not affected by a system
RESET and will revert back to the readings prior
to the system being reset.
Confirm
Cancel
Confirm Reset to
Factory defaults?
CONFIRM
To RESET Synergy, press the RESET icon
on the Home page:
SYSTEM RESET
Press the Reset button for 5
seconds to restore your
Synergy system to factory defaults
RESET
The SYSTEM RESET page will appear:
Press the ‘RESET’ button for 5 seconds
to RESET Synergy. As you press ‘RESET’
you will hear a beeping sound every
second.
After 5 seconds a CONFIRM page will
automatically appear. Press Confirm to
RESET your Synergy system:
To Next Page
Loading...
Need help?
General