40
6. MAINTENANCE
FILTER MAINTENANCE
This Filter Replacement icon will show on the HOME PAGE when either filter requires
cleaning or replacing. Press the icon to take you directly to the FILTER RESET page
to find out which filter is FULL:
This section covers the following maintenance information:
Filter Maintenance 40 & 41
Cleaning the Controller 42
Heat Exchanger Unit Maintenance 42
FILTER RESET
Reset
Reset
F7 Filter FULL
When FULL, please refer to your User Manual for
cleaning/replacement instructions. Press ‘Reset’ after
maintenance is complete.
G3 Filter 18 wks
F7 FILTER REPLACEMENT
The F7 filter’s life span for Smart-Vent Synergy is approximately 1 year (52 weeks)
before reaching 100% filter usage/ FULL.
Once the F7 filter is FULL you will need to replace the filter media. You can purchase
and change this filter yourself as it is just a matter of undoing clips on the in-line
filter (as pictured below) in your roof space and replacing it with the new Filter Media
Box. Alternatively you can contact your installer to purchase and replace it for you.
The filter is located between duct lengths, close to one of the systems fan. You can
purchase your replacement filter from any Electrical Wholesalers by simply quoting
the Securimax order code ‘DCT2093’.
Note: DO NOT reset the filters until you have completed the maintenance.
In-Line F7 Filter Replacement F7 Filter
Media Box
Order Code: DCT2093
Once replaced, press the Reset tab next to the F7 filter as shown. Refer to page 14
To Next Page
Loading...
Need help?
General