17
HEATER
SYSTEM HEATER
An information page providing the
status of your heater (if installed),
showing whether the heater is ON
or OFF and (if ON) which of the 3
modes (Normal, Override or Timer)
is active. This information reads
directly from your settings in the
SYSTEM HEATER pages (refer to
page 35 to set these up).
To access SYSTEM HEATER press the
Heater tab on the SYSTEM Menu page:
HEATER
To change these settings press the Flame on
the right or go back to ‘Settings’ menu
and press ‘Heater’.
Heater currently:
ON
Mode:Normal
Heater
ENABLED
In this example, the heater is enabled
and active (ON) and operating in Normal
mode, which means the heater turns ON
when the Room temperature falls below
your minimum temperature setting.
HEATER
To change these settings press the Flame on
the right or go back to Settings menu
and press ‘Heater’.
Timer 1 ON
06:15 - 09:00
Timer 2 ON
17:30 - 22:30
Heater
ENABLED
Mode:Timer
In this example the heater is in Timer
mode with it programmed to turn ON
at 6:15hrs and OFF at 9:00hrs on Timer
1, and then ON again at 17:30hrs and
OFF at 22:30hrs on Timer 2, provided
the room temperature is below your
minimum temperature setting.
A HEATER page will appear: Shown
below are samples of possible heater
pages:
HEATER
To change these settings press the Flame on
the right or go back to ‘Settings’ menu
and press ‘Heater’.
Heater
DISABLED
In this example the heater has been
‘disabled’ which means under no
circumstances will the heater turn on.
To Next Page
Loading...
Need help?
General