21
CLIMATE
SETTINGS CLIMATE
SETTINGS CLIMATE is the defi ning
setting for the control over your
home comfort.
Some modes are dependent on these
settings being setup such as tempering
heater and Fan Min modes.
The Climate default settings are:
f Minimum Temperature = 18°C
f Comfort Level = Mid Range
Synergy aims to keep your home
environment within this comfort zone by
using these settings in conjunction with
your Heat Boost and Core By-Pass mode
set-up (if installed).
When you press on the CLIMATE tab
there are two available settings
f Min Temp
f Comfort Level
The CLIMATE page is displayed:
MINIMUM TEMP SETTING
This setting is used to control the
optional tempering heater and the
operation of the system fans as set in
the Fan Min Settings.
To set the desired MINIMUM
TEMPERATURE press SETTINGS on the
Home page and then the CLIMATE TAB.
Press the MIN TEMP tab to change the
minimum temperature setting.
Press the UP and DOWN arrows to
increase/decrease the setting as desired.
Once the setting has been entered,
Press the Home button to return
to the Home Page or
Press the Back button to step
back to the SETTINGS Menu.
If any changes have been made to the
settings in this section, Synergy will
prompt you to confi rm your decision.
Refer to page 20 for further instructions
To Next Page
Loading...
Need help?
General