32
When the temperature in the controller
room reaches the pre-set BOOST TEMP
settings the system will automatically
start functioning in the Heat Boost Mode.
When the temperature in the controller
room drops 1˚C below the BOOST TEMP
settings, the system reverts back to a
standard Synergy confi guration.
Note: The default setting and reset setting
for the BOOST TEMP settings is 25˚C.
BOOST TEMPERATURE
When the Heat Boost Mode has
been ‘enabled’, the controller uses
the temperature sensed (the Boost
TEMP) at the wall panel controller to
control the transfer of air from this
heated room.
The BOOST TEMP setting is highlighted
to indicate that this is the active setting.
Use the
arrow to decrease and the
arrow to increase the temperature to
your desired level.
?
HEAT BOOST
Boost Temp
Heat Boost
Max Temp: 26°C
Once the setting has been entered,
Press the Home button to return
to the Home Page or
Press the Back button to step
back to the SETTINGS Menu.
If any changes have been made to the
settings in this section, Synergy will
prompt you to confi rm your decision.
Refer to page 20 for further instructions
To Next Page
Loading...
Need help?
General