33
When Core By-Pass is Disabled
This allows the warm exhausted air from
your home to flow through the Heat
Exchanger to warm the incoming air.
To enable or disable the Core By-Pass
mode press the Core By-Pass tab:
CORE BY-PASS MODE
Synergy has a optional CORE By-pass
upgrade. This mode operates a damper
which allows the fresh inlet air supplied
into your home to by-pass the Heat
Exchanger and therefore it avoids being
warmed by the outgoing, warm exhaust
air.
When Core By-Pass is Enabled
Enable this mode when you wish to
make your home cooler. When enabled
and the room temperature rises
significantly above the set comfort level,
the damper ‘opens’ allowing the inlet air
to bypass the heat recovery core.
Note:
When heating the house, we recommend
disabling Core By-Pass to allow the heat to be
recovered.
To enable or disable the Core By-pass
mode, press SETTINGS then select
MODE:
If there is no Core-By-pass installed an
information page will be displayed:
Press the Core By-Pass tab.
To Next Page
Loading...
Need help?
General