10
Note:
‧
The HDMI interface automatically congure/adjust the audio output to proper format
supported by TV/monitor.
‧
Please use TV volume adjustment to adjust the audio level.
‧
May need to reset TV input to pick up WDVR signal from HDMI.
‧
If your external HDD power requires more than 1A, please use independent power
source to power up the HDD. The 2 USB ports will NOT supply electricity to HDD
at the same time.
INSTALLING YOUR DEVICES
CONNECTING THE WIRELESS DVR TO YOUR TV/MONITOR
1. Connect the supplied receiver antenna and mouse to the back of the receiver.
2. Connect the supplied Ethernet cable from the receiver to router.
3. Connect the supplied HDMI cable from the receiver to HDMI connector on
TV/monitor.
4. Insert memory card / connect HDD to receiver (if applicable).
5. Connect the supplied power adaptor on the receiver to power source (electric wall
socket).
6. Power on the receiver, the Digital Wireless Receiver Console is now ready for use.
7. Turn on TV/monitor and switch to proper HDMI input source.
THE WIRELESS INDICATION
When the DVR and camera are connected and have a good wireless signal, the Green LED
indicator on the camera and the Green Signal LED on the DVR will light up.
To Next Page
Loading...
Need help?
General
