ADJUSTING UPPER LIMIT
ADJUSTING LOWER LIMIT
Every battery motor from SmartWings arrives preprogrammed.
This includes the remote synced with the motor, preset upper and lower operational limits and
an unlocked remote.
Should you need to modify the preset limits, refer to the following instructions.
Press the "H/L switch" button
to switch between control modes.
When the screen shows 'H', it is in
middle rail control mode. When it
displays 'L', it is in bottom rail
control mode.
Press the "H/L switch" button
to switch between control modes.
When the screen shows 'H', it is in
middle rail control mode. When it
displays 'L', it is in bottom rail
control mode.
Move both the middle rail
and the bottom rail to the
positions that you wish to
set as the upper limit.
Press UP & STOP (2 secs)
Press DOWN & STOP (2 secs)
Press UP & STOP (5 secs)
Press DOWN & STOP (5 secs)
Note: the motor jog once.
Note: the motor jog once.
Move both the middle rail
and the bottom rail to the
positions that you wish to
set as the lower limit.
Tips: If you hold the UP/DOWN button for more than 3 seconds, the shade will enter
running mode. As the shade approaches the desired limit, press the STOP button and
then fine-tune the limit.
3
Adjusting Limits
To Next Page
Loading...
Need help?
General
