SMC Networks 2552W-G2 - Page 100

System Configuration
5-54
5
CLI Commands for Radio Settings – From the global configuration mode, enter the
interface wireless g command to access the 802.11g radio interface. From the
802.11g interface mode, you can access radio settings that apply to all VAP
interfaces. Use the turbo command to enable this feature before setting the radio
channel with the channel command. Set any other radio setting as required before
enabling the VAP interface (with the no shutdown command). To view the current
802.11g radio settings for the VAP interface, use the show interface wireless g
[0~7] command as shown on 6-94.
Enterprise AP(config)#interface wireless g 6-87
Enter Wireless configuration commands, one per line.
Enterprise AP(if-wireless g)#super-g 6-103
Enterprise AP(if-wireless g)#channel 42 6-96
Enterprise AP(if-wireless g)#transmit-power full 6-96
Enterprise AP(if-wireless g)#speed 9 6-95
Enterprise AP(if-wireless g)#antenna id 0000 6-99
Enterprise AP(if-wireless g)#antenna control right 6-98
Enterprise AP(if-wireless g)#antenna location indoor 6-100
Enterprise AP(if-wireless g)#mic_mode hardware 6-119
Enterprise AP(if-wireless g)#super-g 7-104
Enterprise AP(if-wireless g)#beacon-interval 150 6-100
Enterprise AP(if-wireless g)#beacon-interval 150 6-100
Enterprise AP(if-wireless g)#dtim-period 5 6-101
Enterprise AP(if-wireless g)#multicast-data-rate 6 6-95
Enterprise AP(if-wireless g)#fragmentation-length 512 6-101
Enterprise AP(if-wireless g)#rts-threshold 256 6-102
Enterprise AP(if-wireless g)#