SMC Networks 2552W-G2 - General Commands

General Commands
6-7
6
The access mode shown in the following tables is indicated by these abbreviations:
Exec (Executive Mode), GC (Global Configuration), IC-E (Interface-Ethernet
Configuration), IC-W (Interface-Wireless Configuration), and IC-W-VAP
(Interface-Wireless VAP Configuration).
General Commands
SNMP Configures community access strings and trap managers 6-39
Flash/File Manages code image or access point configuration files 6-54
RADIUS Configures the RADIUS client used with 802.1X authentication 6-57
802.1X Authentication Configures 802.1X authentication 6-64
MAC Address
Authentication
Configures MAC address authentication 6-69
Filtering Filters communications between wireless clients, controls access to the
management interface from wireless clients, and filters traffic using
specific Ethernet protocol types
6-72
WDS Bridge Configures WDS forwarding table settings 6-76
Spanning Tree Configures spanning tree parameters 6-82
Ethernet Interface Configures connection parameters for the Ethernet interface 6-87
Wireless Interface Configures radio interface settings 6-92
Wireless Security Configures radio interface security and encryption settings 6-108
Rogue AP Detection Configures settings for the detection of rogue access points in the
network
6-108
Link Integrity Configures a link check to a host device on the wired network 6-122
IAPP Enables roaming between multi-vendor access points 6-126
VLANs Configures VLAN membership 6-127
WMM Configures WMM quality of service parameters 6-129
Table 6-3. General Commands
Command Function Mode Page
configure Activates global configuration mode Exec 6-8
end Returns to previous configuration mode GC, IC 6-8
exit Returns to the previous configuration mode, or exits the CLI any 6-8
ping Sends ICMP echo request packets to another node on the
network
Exec 6-9
reset Restarts the system Exec 6-10
show history Shows the command history buffer Exec 6-10
show line Shows the configuration settings for the console port Exec 6-11
Table 6-2. Command Groups
Command Group Description Page