SMC Networks 2552W-G2 - Bridge-Link Child

Command Line Interface
6-78
6
Default Setting
None
Command Mode
Interface Configuration (Wireless)
Command Usage
Every bridge (except the root bridge) in the wireless bridge network must
specify the MAC address of the parent bridge that is linked to the root bridge,
or the root bridge itself.
Example
bridge-link child
This command configures the MAC addresses of child bridge nodes.
Syntax
bridge-link child <index> <mac-address>
- index - The link index number of the child node. (Range: 1 - 6)
- mac-address - The wireless MAC address of a child bridge unit.
(12 hexadecimal digits in the form “xx-xx-xx-xx-xx-xx”).
Default Setting
None
Command Mode
Interface Configuration (Wireless)
Command Usage
• Up to six child bridge links can be specified using link index numbers 1 to 6.
Example
Enterprise AP(if-wireless g)#bridge-link parent 00-08-2d-69-3a-51
Enterprise AP(if-wireless g)#
Enterprise AP(if-wireless g)#bridge-link child 2 00-08-3e-84-bc-6d
Enterprise AP(if-wireless g)#bridge-link child 3 00-08-3e-85-13-f2
Enterprise AP(if-wireless g)#bridge-link child 4 00-08-3e-84-79-31
Enterprise AP(if-wireless g)#