Introduction
1-6
1
System Defaults
The following table lists some of the access point’s basic system defaults. To reset
the access point defaults, use the CLI command “reset configuration” from the Exec
level prompt.
Table 1-1. System Defaults
Feature Parameter Default
Identification System Name SMC
Administration User Name admin
Password smcadmin
General
HTTP Server Enabled
HTTP Server Port 80
HTTP Server Enabled
HTTP Server Port 443
TCP/IP DHCP Enabled
IP Address 192.168.2.2
Subnet Mask 255.255.255.0
Default Gateway 0.0.0.0
Primary DNS IP 0.0.0.0
Secondary DNS IP 0.0.0.0
RADIUS (Primary and
Secondary)
IP Address 0.0.0.0
Port 1812
Key DEFAULT
Timeout 5 seconds
Retransmit attempts 3
Accounting Port 0 (Disabled)
Interim Update Timeout 3600 seconds
SSH Server Status Enabled
Server Port 22
PPPoE PPPoE Status Disabled
To Next Page
Loading...
