Command Line Interface
6-94
6
interface wireless
This command enters wireless interface configuration mode.
Syntax
interface wireless <g>
• g - 802.11g radio interface.
Default Setting
None
Command Mode
Global Configuration
Example
To specify the 802.11g interface, enter the following command:
vap
This command provides access to the VAP (Virtual Access Point) interface
configuration mode.
Syntax
vap <vap-id>
vap-id - The number that identifies the VAP interface. (Options: 0-7)
Default Setting
None
Command Mode
Interface Configuration (Wireless)
Example
Enterprise AP(config)#interface wireless g
Enterprise AP(if-wireless g)#
Enterprise AP(if-wireless g)#vap 0
Enterprise AP(if-wireless g: VAP[0])#
To Next Page
Loading...
