Wireless Interface Commands
6-93
6
beacon-interval Configures the rate at which beacon signals are
transmitted from the access point
IC-W 6-100
dtim-period Configures the rate at which stations in sleep mode
must wake up to receive broadcast/multicast
transmissions
IC-W 6-101
fragmentation- length Configures the minimum packet size that can be
fragmented
IC-W 6-101
rts-threshold Sets the packet size threshold at which an RTS must
be sent to the receiving station prior to the sending
station starting communications
IC-W 6-102
super-a Enables Atheros proprietary Super A performance
enhancements
IC-W (a) 7-105
super-g Enables Atheros proprietary Super G performance
enhancements
IC-W (b/g) 6-103
description Adds a description to the wireless interface IC-W-VAP 6-103
ssid Configures the service set identifier IC-W-VAP 6-104
closed system Opens access to clients without a pre-configured
SSID
IC-W-VAP 6-104
max-association Configures the maximum number of clients that can
be associated with the access point at the same time
IC-W-VAP 6-105
assoc- timeout-interval Configures the idle time interval (when no frames are
sent) after which a client is disassociated from the
VAP interface
IC-W-VAP 6-105
auth- timeout-value Configures the time interval after which clients must
be re-authenticated
IC-W-VAP 6-105
shutdown Disables the wireless interface IC-W-VAP 6-106
show interface wireless Shows the status for the wireless interface Exec 6-107
show station Shows the wireless clients associated with the access
point
Exec 6-108
Table 6-17. Wireless Interface Commands
Command Function Mode Page
To Next Page
Loading...
