SMC Networks 2552W-G2 - Flash;File Commands; Bootfile

Command Line Interface
6-54
6
Flash/File Commands
These commands are used to manage the system code or configuration files.
bootfile
This command specifies the image used to start up the system.
Syntax
bootfile <filename>
filename - Name of the image file.
Default Setting
None
Command Mode
Exec
Command Usage
• The file name should not contain slashes (\ or /), the leading letter of the file
name should not be a period (.), and the maximum length for file names is
32 characters. (Valid characters: A-Z, a-z, 0-9, “.”, “-”, “_”)
• If the file contains an error, it cannot be set as the default file.
Example
Table 6-10. Flash/File Commands
Command Function Mode Page
bootfile Specifies the file or image used to start up the system GC 6-54
copy Copies a code image or configuration between flash
memory and a FTP/TFTP server
Exec 6-55
delete Deletes a file or code image Exec 6-56
dir Displays a list of files in flash memory Exec 6-57
show bootfile Displays the name of the current operation code file that
booted the system
Exec 6-57
Enterprise AP#bootfile -img.bin
Enterprise AP#