Command Line Interface
6-92
6
Example
Wireless Interface Commands
The commands described in this section configure connection parameters for the
wireless interfaces.
Enterprise AP#show interface ethernet
Ethernet Interface Information
========================================
IP Address : 192.168.2.2
Subnet Mask : 255.255.255.0
Default Gateway : 192.168.1.253
Primary DNS : 192.168.1.55
Secondary DNS : 10.1.0.55
Speed-duplex : 100Base-TX Half Duplex
Admin status : Up
Operational status : Up
========================================
Enterprise AP#
Table 6-17. Wireless Interface Commands
Command Function Mode Page
interface wireless Enters wireless interface configuration mode GC 6-94
vap Provides access to the VAP interface configuration
mode
IC-W 6-94
speed Configures the maximum data rate at which the
access point transmits unicast packets
IC-W 6-95
turbo Configures turbo mode to use a faster data rate IC-W (a) 7-96
multicast-data-rate Configures the maximum rate for transmitting
multicast packets on the wireless interface
IC-W 6-95
channel Configures the radio channel IC-W 6-96
transmit-power Adjusts the power of the radio signals transmitted
from the access point
IC-W 6-96
radio-mode Forces the operating mode of the 802.11g radio IC-W (b/g) 6-97
preamble Sets the length of the 802.11g signal preamble IC-W (b/g) 6-98
antenna control Selects the antenna control method to use for the
radio
IC-W 6-98
antenna id Selects the antenna ID to use for the radio IC-W 6-99
antenna location Selects the location of the antenna IC-W 6-100
To Next Page
Loading...
