SMC Networks 2552W-G2 - Page 122

System Configuration
5-76
5
CLI Commands for WEP over 802.1X Security – Use the vap command to access
each VAP interface to configure the security settings. First set 802.1X to required
using the 802.1x command and set the 802.1X key refresh rates. Then, use the
authentication command to select open system authentication and the encryption
command to enable data encryption. To view the current security settings, use the
show interface wireless g 0 command (not shown in example).
AC0(Best Effort) : logCwMin: 4 logCwMax: 6
AIFSN: 3
Admission Control: No
TXOP Limit: 0.000 ms
AC1(Background) : logCwMin: 4 logCwMax: 10
AIFSN: 7
Admission Control: No
TXOP Limit: 0.000 ms
AC2(Video) : logCwMin: 3 logCwMax: 4
AIFSN: 1
Admission Control: No
AC3(Voice) : logCwMin: 2 logCwMax: 3
AIFSN: 1
Admission Control: No
TXOP Limit: 1.504 ms
TXOP Limit: 3.008 ms
===============================================================
Enterprise AP#
Enterprise AP(if-wireless g)#vap 0
Enterprise AP(if-wireless g: VAP[0])#802.1X required 6-64
Enterprise AP(if-wireless g: VAP[0])#802.1X
broadcast-key-refresh-rate 5 6-65
Enterprise AP(if-wireless g: VAP[0])#802.1X
session-key-refresh-rate 5 6-66
Enterprise AP(if-wireless g: VAP[0])#802.1X session-timeout 300
6-66
Enterprise AP(if-wireless g: VAP[0])#interface wireless g6-87
Enter Wireless configuration commands, one per line.
Enterprise AP(if-wireless g: VAP[0])#authentication open6-116
Enterprise AP(if-wireless g: VAP[0])#encryption 6-115
Enterprise AP(if-wireless g: VAP[0])#