System Configuration
5-84
5
• 802.1X Reauthentication Refresh Rate: The time period after which a connected
client must be re-authenticated. During the re-authentication process of verifying
the client’s credentials on the RADIUS server, the client remains connected the
network. Only if re-authentication fails is network access blocked. (Range: 0-65535
seconds; Default: 0 means disabled)
CLI Commands for 802.1X Authentication – Use the 802.1X supported command
from the VAP interface mode to enable 802.1X authentication. Set the session and
broadcast key refresh rate, and the re-authentication timeout. To display the current
settings, use the show authentication command from the Exec mode.
Enterprise AP(if-wireless g: VAP[0])#802.1X supported 6-64
Enterprise AP(if-wireless g: VAP[0])#802.1X
broadcast-key-refresh-rate 5 6-65
Enterprise AP(if-wireless g: VAP[0])#802.1X
session-key-refresh-rate 5 6-66
Enterprise AP(if-wireless g: VAP[0])#802.1X
session-timeout 300 6-66
Enterprise AP(if-wireless g: VAP[0])#exit
Enterprise AP#show authentication 6-67
Authentication Information
===========================================================
MAC Authentication Server : DISABLED
MAC Auth Session Timeout Value : 0 min
802.1x supplicant : DISABLED
802.1x supplicant user : EMPTY
802.1x supplicant password : EMPTY
Address Filtering : ALLOWED
System Default : ALLOW addresses not found in filter table.
Filter Table
MAC Address Status
----------------- ----------
00-70-50-cc-99-1a DENIED
00-70-50-cc-99-1b ALLOWED
=========================================================
Enterprise AP#
To Next Page
Loading...
