SMC Networks 2552W-G2 - Page 138

System Configuration
5-92
5
CLI Commands for Displaying the Logging Status – From the global configuration
mode, use the show logging command.
CLI Commands for Displaying Event Logs – To view the access point log entries,
use the show event-log command from the Exec mode. To clear all log entries from
the access point, use the logging clear command from the Global Configuration
mode.
Enterprise AP#show loggging 6-31
Logging Information
============================================
Syslog State : Enabled
Logging Console State : Enabled
Logging Level : Alert
Logging Facility Type : 16
Servers
1: 192.168.1.19, UDP Port: 514, State: Enabled
2: 0.0.0.0, UDP Port: 514, State: Disabled
3: 0.0.0.0, UDP Port: 514, State: Disabled
4: 0.0.0.0, UDP Port: 514, State: Disabled
=============================================
Enterprise AP#
Enterprise AP#show event-log 6-32
Mar 09 11:57:55 Information: 802.11g:11g Radio Interface
Enabled
Mar 09 11:57:55 Information: 802.11g:Radio channel updated to
8
Mar 09 11:57:34 Information: 802.11g:11g Radio Interface
Enabled
Mar 09 11:57:18 Information: 802.11g:11g Radio Interface
Enabled
Mar 09 11:55:52 Information: SSH task: Set SSH server port to
22
Mar 09 11:55:52 Information: SSH task: Enable SSH server.
Mar 09 11:55:52 Information: Enable Telnet.
Mar 09 11:55:40 Information: 802.11g:11g Radio Interface
Disabled
Mar 09 11:55:40 Information: 802.11g:Transmit Power set to
QUARTER
Press <n> next. <p> previous. <a> abort. <y> continue to end :
Enterprise AP#configure
Enter configuration commands, one per line. End with CTRL/Z
Enterprise AP(config)#logging clear 6-31
Enterprise AP#