System Configuration
5-4
5
CLI Commands for System Identification – Enter the global configuration mode, and
use the system name command to specify a new system name. Then return to the
Exec mode, and use the show system command to display the changes to the
system identification settings.
Enterprise AP#config
Enterprise AP(config)#system name R&D 6-14
Enterprise AP(config)#end 6-87
Enterprise AP#show system 6-22
Enterprise AP#config 6-8
Enter configuration commands, one per line.
Enterprise AP(config)#system name R&D 6-14
Enterprise AP(config)#end 6-87
Enterprise AP#show system 6-22
System Information
==============================================================
Serial Number :
System Up time : 0 days, 0 hours, 32 minutes, 22 seconds
System Name : R&D
System Location :
System Contact : Contact
System Country Code : US - UNITED STATES
MAC Address : 00-12-CF-12-34-60
Radio A MAC Address : 00-12-CF-12-34-61
Radio G MAC Address : 00-12-CF-12-34-65
IP Address : 192.168.2.2
Subnet Mask : 255.255.255.0
Default Gateway : 0.0.0.0
VLAN State : DISABLED
Management VLAN ID(AP): 1
IAPP State : ENABLED
DHCP Client : ENABLED
HTTP Server : ENABLED
HTTP Server Port : 80
HTTPS Server : ENABLED
HTTPS Server Port : 443
Slot Status : Single band(b/g)
Boot Rom Version : v1.1.5
Software Version : v5.0.0.0
SSH Server : ENABLED
SSH Server Port : 22
Telnet Server : ENABLED
DHCP Relay : DISABLED
==============================================================
Enterprise AP#
To Next Page
Loading...
