Advanced Configuration
5-29
5
CLI Commands for the Administrator’s User Name and Password – Use the
username and password commands from the CLI configuration mode.
Upgrading Firmware
You can upgrade new access point software from a local file on the management
workstation, or from an FTP or TFTP server. New software may be provided
periodically from your distributor.
After upgrading new software, you must reboot the access point to implement the
new code. Until a reboot occurs, the access point will continue to run the software it
was using before the upgrade started. Also note that new software that is
incompatible with the current configuration automatically restores the access point to
the factory default settings when first activated after a reboot.
Enterprise AP(config)#username bob 6-15
Enterprise AP(config)#password admin 6-15
Enterprise AP#
To Next Page
Loading...
