SNMP
5-41
5
• dot11StationAuthenticateFail - A client station has tried and failed to authenticate
to the network.
• Enable All Traps - Click the button to enable all the available traps.
• Disable All Traps - Click the button to disable all the available traps.
CLI Commands for SNMP and Trap Configuration – Use the snmp-server enable
server command from the global configuration mode to enable the SNMP agent.
Use the snmp-server location and snmp-server contact commands to indicate
the physical location of the access point and define a system contact. To set the
read-only and read/write community names, use the snmp-server community
command. Use the snmp-server host command to define a trap receiver host and
the snmp-server trap command to enable or disable specific traps.
Enterprise AP(config)#snmp-server enable server 6-41
Enterprise AP(config)#snmp-server community alpha rw 6-40
Enterprise AP(config)#snmp-server community beta ro
Enterprise AP(config)#snmp-server location WC-19 6-41
Enterprise AP(config)#snmp-server contact Paul 6-40
Enterprise AP(config)#snmp-server host 192.168.1.9 alpha6-42
Enterprise AP(config)#snmp-server trap dot11StationAssociation
6-43
Enterprise AP(config)#
To Next Page
Loading...
