S
ETTING
U
P
TCP/IP
TO
W
ORK
WITH
THE
B
ARRICADE
5-42
Manual IP Configuration
1. Check “Specify an IP address” on the IP Address tab. Enter an IP
address based on the default network 192.168.2.x (where x is
between
2 and 254), and use 255.255.255.0 for the subnet mask.
2. On the “Gateway” tab, add the IP address of the Barricade (default:
192.168.2.1) in the “New gateway” field and click “Add.”
3.
On the “DNS Configuration” tab, add the IP address for the Barricade
and
click “Add.” This automatically relays DNS requests to the DNS
server(s) provided by your ISP. Otherwise, add specific
DNS servers
into the “DNS Server Search Order” field and click “Add
.
”
4. After finishing TCP/IP setup, click “OK,” and then reboot the
computer. After that, set up other PCs on the LAN according to the
procedures described above.
To Next Page
Loading...
