P
OWERING
O
N
THE
S
WITCH
7
Powering On the Switch
1. Plug the power cord into the power socket at the rear of the switch,
and the other end into a power outlet.
2. Check the LED marked Power on the front panel to see if it is on. The
unit will automatically select the setting that matches the connected
input voltage. Therefore, no additional adjustments are necessary
when connecting it to any input voltage within the range marked on
the rear panel.
3. The switch performs a self-diagnostic test upon power-on. (Note that
this test takes several seconds to complete.)
Note: The unit supports a “hot remove” feature which permits you to
connect or disconnect twisted-pair cables without powering off
the switch and without disrupting the operation of the devices
attached to the switch.
To Next Page
Loading...
Need help?
General
