-11-
Request timed out.
there has been an error in your installation procedure. Please go through the following
checklist to ensure proper installation:
1. Is the Ethernet cable correctly connected between the Barricade and your computer?
Tip: The LAN LED of the Barricade and the link LED of the network card on your
computer must be lit.
2. Is the TCP/IP environment of your computer properly configured?
Tip: If the IP address of the Barricade is 192.168.123.254, the IP address of your
computer must be 192.168.123.X and default gateway must be 192.168.123.254.
3.2 Install the Software into Your Computers
Skip this section if you do not want to use the print server function of the Barricade.
Step 1: Insert the installation CD into your computer’s CD-ROM drive. The following
window will be shown automatically. If it is not, please run “install.exe” on the
CD-ROM.
To Next Page
Loading...
