13 Specification for Option V
13 - 1
13 Specification for Option V
This option installs the timer operated auto drain. When performing the installation and maintenance
work for the product, the following points must be understood and followed. Additionally, read 12-3 for
maintenance work.
13-1 Safety instructions
When handling the product, take care of the following precautions.
1. Do not remove the auto drain if air pressure remains in the product. When removing the
auto drain, stop the supply of air to the primary side of the product, exhaust the air from the
secondary side and ensure there is no residual pressure. If the air pressure is left at the
inside of the product, parts could suddenly pop out and cause accident when loosened.
2. Put gloves to prevent injury when removing the auto drain.
3. Operator could touch the drain waste when repalcing the auto drain. Follow the procedures
prepared by the customer to ensure the safety of the operators. (Ex. Put protective goggles,
apron and/or gloves to protect body from toucing the drain waste when performing
maintenance on the unit.)
Only qualified people must perform wiring.
1. Provide the power suitable for the product specifications.
2. Be sure to ground the product for safety. Do not ground to water pipe, gas tube or
lightening rod line.
3. Do not connect too many wires to the same outlet, which could results in heat generation
and fire.
4. Do not retrofit the wiring of the dryer and the power supply line.
To Next Page
Loading...
Need help?
General