-10-
No.LFE****-OMZ0012
* Adjustment and Operation
- Check the load status before turning the power supply on.
- Do not short-circuit the load.
Over current may lead to the damage of the product.
- Supply the power when there is no flow.
- There will be a drift on the analogue output for 5 minutes after the power supply is turned on.
- The product doesn’t produce and output signal for 3 seconds after the power is supplied.
* Maintenance
- Confirm safety by turning off the power supply and stopping the flow before performing maintenance.
There is a risk of unexpected malfunction.
- Perform regular maintenance and inspections.
There is a risk of unexpected failure of components due to the malfunction of equipment and machinery.
- Do not use solvents such as benzene, thinner etc. to clean the product.
This may damage the surface of the body or erase the markings on the body.
Use a soft cloth to remove stains.
For heavy stains, use a cloth soaked with diluted neutral detergent and fully squeezed, then wipe up the stains
again with a dry cloth.
To Next Page
Loading...
