To Next PageTo Next Page
Need help?Do you have a question about the SMC Networks PTE-100-C and is the answer not in the manual?
General| Brand | SMC Networks |
|---|---|
| Model | PTE-100-C |
| Category | Test Equipment |
| Language | English |
Explains the blend of digital and traditional analog technologies used.
Details the classical design using a variac and transformers.
Covers the two independent auxiliary voltage outputs.
Explains analogue input conversion and measured magnitudes.
Details the AC supply block with power cord, fuse holder, and switch.
Describes the type and location of fuses used for protection.
Explains how to connect and disconnect the main power output.
Describes the knob controlling output level and its scale.
Lists the four taps for current injection and common reference.
Details the AC voltage output tap with its specifications.
Details the DC voltage output tap with its specifications.
Explains how to select which output is shown on Display #2.
Describes the button to identify the current tap in use to the instrument.
Details the I Therm and I Lim alarms indicating overload or overheating.
Details the variable DC auxiliary output and its connection.
Explains the protections and indicators for Out 3.
Describes the fixed AC auxiliary output.
Explains the inputs used to detect relay operation for timing.
Refers to Display #1 for time values and other measurement units.
Describes how to adapt timer start/stop conditions using mode buttons.
Instructions for measuring external voltage or frequency.
How to obtain load voltage, impedance, and power data.
Explains Ilim and Tlim functions to protect devices.
Steps to test instantaneous overcurrent relays using specific functions.
Method to set a current value before output activation using Preset.
Details the standard DB-9 serial connector and its pinout.
Describes the proprietary high-speed bus for linking EuroSMC products.
Explains how to apply electrical magnitudes to a tested device.
Step-by-step guide for injecting AC current into a load.
Details the automatic output stop and blinking LED on overload.
Procedure for voltage injection, noting exceptions to current injection.
Details the variable DC auxiliary output and its connection.
Explains the protections and indicators for Out 3.
Describes the fixed AC auxiliary output.
Explains how the monitor input detects relay operation to stop tests.
Discusses timer start/stop modes within the context of testing operation time.
Lists the necessary items for calibration.
Outlines the steps for calibrating via PC software.
Details output current and voltage characteristics.
Specifies the input voltage range and frequency.
Lists the physical size and weight of the unit.
Details warranty coverage and exclusions for product defects.
Information on material supply and technical service availability.
Lists other related products offered by EuroSMC.
