I
NSTALLATION
2-8
Notes: 1. Use 100-ohm shielded or unshielded twisted-pair cable with
RJ-45 connectors for all connections. Use Category 3, 4 or 5
for connections that operate at 10 Mbps, and Category 5 for
connections that operate at 100 Mbps.
2. Make sure each twisted-pair cable does not exceed 100 meters
(328 feet).
Figure 2-4. Making LAN Connections
Attach to Your Network Using Radio Signals
Install a wireless network adapter in each computer that will be connected
to the Internet or your local network via radio signals. SMC currently
offers several wireless network cards, including the
SMC2602W Wireless
PCI card and the SMC2632W Wireless PC card.
Rotate both antennas on the back of the Wireless Barricade to the desired
position. For more effective coverage, position one antenna along the
vertical axis and the other along the horizontal axis. Try to place the
Wireless Barricade in a position that is located in the center of
your
wireless network. Normally, the higher you place the antenna,
the better the
performance. Ensure that the Wireless Barricade’s location provides
optimal reception throughout your home or office.
RESET
9V
2 A MAX
To Next Page
Loading...
