Installing the Gateway
20
SMCD3GNV Wireless Cable Modem Gateway User Manual
Installing a Battery
To install a battery into the Gateway, use the following procedure.
1. Place the Gateway on its side on a table.
2. Remove battery compartment door on the bottom panel and set it aside (see Figure 4).
Figure 4. Removing the Battery Compartment Door
3. Insert the battery into the battery compartment (see Figure 5).
Figure 5. Installing the Battery
4. Close the battery compartment.
Note: Using the Battery menu in the Gateway’s Web interface, you can view status
information about the battery (see “Viewing Battery Settings” on page 57).
To Next Page
Loading...
