SMC Networks ZSE40A(F)

-39-
No.PS※※-OMM0007-H
■[F11] Display resolution
This function is used to change the pressure display resolution.
This can be used to prevent the digits from flickering on the display.
<Operation>
Press the or button in function selection mode to display [F11].
Press the button. Move on to setting of display resolution.
Press the button to set. Return to function selection mode.
Setting of [F11] Display resolution completed
: Not selectable depending on the selected display units.
The display resolution selectable unit is MPa, kPa (for ZSE only), kgf/cm
2
, bar, psi and inHg.
The display units kgf/cm
2
, bar, psi and inHg are selectable only for models with the units selection function.
[F 0] Units selection function on page 27.
Setting of display resolution
Press the
or
button to select display
resolution.