SMC Networks ZSE40A User Manual

-18-
No.PS※※-OMM0007-H
■Piping
○Connection using screw type piping
Connect suitable piping to the port.
Hold the hexagon part of the piping port and fix. The required tightening torque is 7 to 9 Nm.
When using an M5 female fitting confirm the fitting specification.
○Connection using One-touch fitting
1. Cut the tube end perpendicular.
2. Hold the tube and insert it into the One-touch fitting slowly until it bottoms out.
Warning
■Do not use the product in a place where electrical static charge will be a problem.
It can cause the error and damage to the system.
Allow sufficient tube length to prevent twist and tensile or moment loads from being applied to the fitting or
tube.
When using a tube manufactured by a company other than SMC, check that its outside diameter tolerance
satisfies the following values:
1) Nylon tube: ±0.1 mm maximum
2) Soft nylon tube: ±0.1 mm maximum
3) Polyurethane tube: +0.15 mm/-2 mm maximum

SMC Networks ZSE40A Specifications

General

Brand	SMC Networks
Model	ZSE40A
Category	Switch
Language	English