Smeg CW510 - User Manual

Questions and Answers

A
Ashley ChandlerJul 30, 2025
Why are my Smeg CW510 washing results poor?
- C
  Chad BallJul 30, 2025
  Poor washing results in your Smeg Dishwasher can stem from several causes. Check the following: * Ensure the spray arm washing holes aren't blocked by dirt or limescale. * Confirm the filter isn't fouled. * Verify you're using the correct type and amount of detergent or rinse aid. * Make sure plates and glasses are arranged correctly. * Check the washing temperature displayed; if it's below 50°C, contact after-sales service.
B
Brett WilliamsAug 3, 2025
Why are the dishes not properly dried in my Smeg CW510 Dishwasher?
- L
  lopezbrettAug 3, 2025
  If your dishes aren't drying properly in your Smeg Dishwasher, it might be due to a low rinsing temperature. Ensure that the water supplying the appliance is at least at 50°. If the problem persists call the after? sales service.
M
Miss Emily Hunter DDSAug 9, 2025
What to do if my Smeg CW510 leaves stains on glasses and cutlery?
- G
  George DavisAug 9, 2025
  If your Smeg Dishwasher is leaving stains on glasses and cutlery, the issue may be related to the rinse aid or water hardness. Check if the rinse aid is suitable for your type of mains water. If the water hardness is above 12°dF or there are large amounts of dissolved salts, and the problem persists, contact the after-sales service.
B
Benjamin FreemanAug 13, 2025
Why is my Smeg CW510 Dishwasher not rinsing adequately?
- J
  Jeff YoungAug 14, 2025
  Inadequate rinsing in your Smeg Dishwasher could be due to a few reasons. First, check the dynamic pressure of the mains water to ensure it's sufficient. Also, inspect the spray arm nozzles for any fouling and clean them. If limescale in boiler is the issue, and you are unable to solve the problem, call the after?sales service.
J
james36Aug 19, 2025
What to do if there's water in the tank of my Smeg CW510 Dishwasher after pump-out?
- H
  Haley MillerAug 19, 2025
  If you find water remaining in the tank of your Smeg Dishwasher after it pumps out, it could be due to the drain hose. Check that the dishwasher drain hose and rain are unobstructed and the drain is not too high up; see connection diagram.
A
Anthony GalvanAug 23, 2025
How to fix Smeg CW510 when light L1 does not come on?
- J
  Jamie EstradaAug 25, 2025
  If light L1 on your Smeg Dishwasher isn't turning on, it could be due to a mains power failure. Check the electrical mains connection.