Smeg CWG410M - User Manual

Questions and Answers

J
John RodriguezJul 31, 2025
Why is my Smeg CWG410M not washing properly?
- E
  ehaydenJul 31, 2025
  If your Smeg Dishwasher isn't cleaning dishes well, several factors could be at play. Start by ensuring the spray arm washing holes aren't blocked and that the filter isn't dirty. Also, verify that you're using the correct type and amount of detergent and that the plates and glasses are arranged properly. If the dirt has dried on, try increasing the wash cycle duration. Check the temperature shown on the display, call the after?sales service if less than 50°C. Finally, ensure that the intake filter is not fouled. If you are unable to solve the problem, call the after?sales service.
E
Elizabeth BarrettAug 7, 2025
What to do if my Smeg CWG410M is not rinsing well?
- M
  michaela85Aug 7, 2025
  If your Smeg Dishwasher isn't rinsing properly, start by checking the mains water pressure to ensure it's sufficient. Also, inspect the spray arm nozzles to make sure they aren't blocked. If there is limescale in boiler, clean rinsing nozzles. If you are unable to solve the problem, call the after?sales service.
J
jilldavisAug 15, 2025
Why does my Smeg CWG410M leave stains on glasses and cutlery?
- H
  Heather HansenAug 15, 2025
  If your Smeg Dishwasher leaves stains on glasses and cutlery, it might be due to unsuitable rinse aid or incorrect delivery. Check the rinse aid container to ensure it's appropriate for your water type. If the problem persists, contact the after?sales service.
B
Brittney BraunAug 22, 2025
What to do if there's water in the tank of my Smeg CWG410M Dishwasher after pump-out?
- C
  chayesAug 22, 2025
  If there's water in the tank of your Smeg Dishwasher after pumping out, the drain hose might be incorrectly positioned or partially blocked. Check that the dishwasher drain hose and rain are unobstructed and the drain is not too high up; see connection diagram.

Summary

1 PRECAUTIONS FOR SAFETY AND USE

3 INSTALLATION AND POSITIONING

4 INSTRUCTIONS FOR TECHNICAL STAFF

4.1 Plumbing hookup

Connects water supply and drain hoses to the appliance.

4.2 Electrical connection

Details on connecting the dishwasher to the electrical system by authorized staff.

5 FIRST START-UP

6 SET-UP

6.3 Parameter programming procedure

Step-by-step guide on how to access and modify appliance parameters.

6.4 Modifiable parameters

Lists adjustable parameters like appliance type, temperatures, and offsets.

7 MALFUNCTIONS SHOWN ON THE DISPLAY (FOR THE TECHNICIAN)

E.5 Tank overheating.

8 INSTRUCTIONS FOR THE USER

8.3 First use each day (tank and boiler empty)

8.4 Choosing the program

9 MAINTENANCE AND CLEANING

9.1 Daily cleaning of filters

10 TROUBLESHOOTING

11 MALFUNCTIONS SHOWN ON THE DISPLAY (FOR THE USER)

E.3 Water intake malfunction

Explains the error code for water intake issues.

E.4 Boiler overheating.

Explains the error code for boiler overheating.

E.5 Tank overheating

E.6 Water not pumped out of tank

Explains the error code for water not being pumped out.

E.7 Boiler heating malfunction (does not heat up)

Explains the error code for the boiler not heating up.

E.8 Tank heating malfunction (does not heat up)

Explains the error code for the tank not heating up.

E.9 Microprocessor failure