Smeg CW520 - User Manual

Questions and Answers

L
luis93Jul 30, 2025
Why is my Smeg CW520 not cleaning properly?
- G
  Gregory KleinJul 30, 2025
  Poor washing results from your Smeg Dishwasher can stem from several causes. Check if the spray arm washing holes are blocked by dirt or limescale. Also, ensure the filter is clean. Insufficient or unsuitable detergent or rinse aid could be the issue; verify the type and quantity you're using. Make sure plates and glasses are arranged correctly and that the cycle set is appropriate for the level of dirtiness. Finally, inspect the spray arm nozzles to ensure they are clean.
J
jason50Aug 4, 2025
What to do if Smeg Dishwasher leaves dishes wet?
- G
  George HernandezAug 4, 2025
  If your Smeg Dishwasher isn't drying dishes properly, the rinse aid might be unsuitable or not dispensing correctly. Also, high water hardness or dissolved salts can cause this issue. Check the rinse aid container to ensure it's appropriate for your water type. Consider restoring T Stop ON and/or connecting the appliance to a hot water supply.
J
Jonathan GouldAug 9, 2025
Why is rinsing inadequate in my Smeg CW520?
- E
  Eric BrownAug 9, 2025
  Inadequate rinsing in your Smeg Dishwasher could be due to unsuitable rinse aid or incorrect delivery, or the rinsing temperature being too low. Ensure the rinse aid is appropriate for your water type and check the boiler temperature setting. If the problem continues, contact the after-sales service.
G
garciamorganAug 14, 2025
Why is there water in the tank of my Smeg CW520 Dishwasher after pumping out?
- J
  Jacob SpearsAug 14, 2025
  If there's water in the tank of your Smeg Dishwasher after pumping out, the drain hose might be incorrectly positioned or partially obstructed. Ensure the dishwasher hose and drain are unobstructed, and the drain isn't too high up; see the connection diagram.
R
Raven StewartAug 18, 2025
What to do if my Smeg CW520 Dishwasher shows Err05?
- H
  hgibsonAug 19, 2025
  Check that the water intake tap is on and the dynamic pressure in the intake system, inspect water.
D
Devin SimonAug 25, 2025
Why light S1 doesn't come on in Smeg Dishwasher?
- T
  tonymillerAug 25, 2025
  If light S1 on your Smeg Dishwasher doesn't come on, it could be due to a mains power failure. Check the electrical mains connection.