‐CW520/530
32
Remove the filters (simply lift them out as shown here), taking care
that no large residues fall into the sump underneath. Clean them to
remove residues and rinse with plenty of water, then put them
correctlybackinplace;donotusesharporpointedtools.
Cleanawayanylimescaledepositstopreventexcessivebuild‐ups;
‐ Ifpossible,leavethedoorajarwhennotinuse;
‐ Clean surfaces thoroughly and often with a damp cloth; use
neutral, non‐abrasive detergents which do not use chlorine
compounds,whichcorrodeanddamagestainlesssteel.
Donotusetheproductsmentionedaboveevenwhencleaningthefloorunderneathorinthevicinityof
thedishwasher,
toensurethatfumesordropscannotdamagethesteelsurfaces.
IMPORTANT:Thedishwasherautomaticallyperformsprogram“P0”atthestartofthedayifwaterhas
beenleftinthetankandhasdroppedbelowthetemperatureof40°C
11.2 Routineinspectionofthesprayarms
Removethewashingandrinsing(topandbottom)sprayarmsbyunscrewingthecentralscrew;remove
the rinsing spray arms 3 and remove the screws 2 as shown. Do not unscrew the nozzles. Clean the
holes and nozzles under a jet of clean running water; do not use tools which might cause damage.
Reassemblethesprayarmswithcare.
Cleantheoutsideoftheappliancewithadampclothandneutralsoap,rinsinganddryingthoroughly.
11.3 Lengthyperiodsoutofuse
If the dishwasher is to be out of use for a fairly long period of time, the detergent and rinse aid
dispenserdevicesmustbeemptiedtopreventcrystallisationanddamagetothepumps:Removethe
intakehosesfromthedetergentandrinseaidcontainersandplacetheminacontainerofcleanwater,
thenperformafewwashcyclesfollowedbyacompletepump‐out.
Finally,turnoffthemasterswitch,closethewaterintakevalveandleavethedoorajaruntiltheinterior
iscompletelydry.Thedetergentandrinseaidintakehosesmustbeputbackintothecontainerswhen
the dishwasher is returned to service, taking care not to swap them over (red hose =detergent, blue
hose=rinseaid).
1
1
3
To Next Page
Loading...
