Smeg HTY511DSUK - Page 17

17
Autostart function
Set at “on” to start the cycle when the hood/door is closed.
Set at “off” to start the cycle after confirmation with the
start button .
Regeneration frequency setup (models with softener)
* (Default value: H03; modify the parameter to suit the mains water hardness.
At first use, the salt tank has to be filled. It is subsequently sufficient simply to fill up with
regenerating salt when necessary.
Mains water hardness setting table
Ppm-
mg/l
Durezza
°d gradi
tedeschi
Durezza
°f gradi
francesi
Livello
regolazione
Rigenerazione disattivata
H00
150
8,5
15
H01
200
11
20
H02
300
17
30
* H03
With values over 60°f an external water
treatment device must be used and the
regeneration frequency must be set on H00.
400
22,5
40
H04
500
28
50
H05
600 33,5 60 H06
Importante:
During normal operation, the dishwasher will perform a number of washing cycles while
regeneration is in progress. During this time (5-6 cycles) the intake water will not be treated, but
this will not affect the washing quality.
Extra rinse
Rinsing is 10” longer than the standard in each washing
cycle.
On: enabled – OFF: disabled.