Smeg HTY511DSUK - Modifiable Parameters

16
7.2 Modifiable parameters
The illustrations are purely guideline. The minimum and maximum temperatures
available depend on the model (glass washer, dishwasher, undercounter or hood-
type model, ..).
Rinsing temperature
(boiler temperature)
Washing temperature
(tank temperature)
Warning: The tank and boiler temperatures shown on the display may be different from the
actual temperatures by a few degrees, especially in transient phases (just after the FILL is
completed, just after the end of the cycle, etc.) due to the inertia of the measurement probe.
Adjusting rinse aid dispensing (optional if installed)
Every time is
pressed, the value
increases of 0,1 g/l up
to a max. of 2 g/l.
Default: 1,2 g/l.
Adjusting detergent dispensing (optional if installed)
From 0,0 g/l to 3,0 g/l every time is pressed, the value increases of 0,2 g/l.
Beyond 3,0 g/l every time is pressed, the value increases 1,0 g/l up to 10,0 g/l (maximum
value).
Factory-set default value = 2 gr/lt.