Smeg HTY511DSUK - Malfunctions Shown on the Display (For the User); User Error Codes and Actions

34
14 MALFUNCTIONS SHOWN ON THE DISPLAY (FOR THE USER)
The dishwasher can show a series of malfunctions on display.
After the machine has been switched off and restarted, if the problem is not solved, follow the steps
below:
( FOR A MORE PROFICIENT AFTER-SALES SERVICE, ALWAYS TAKE NOTE OF THE INDICATED
ERROR )
Err04
Tank temperature probe anomaly
Contact After
-
sales Service
Err05
Tank water filling anomaly
Check that the water supply tap is open, the dynamic
supply pressure, cleanliness of the inlet water filter. If the
problem still occurs,
contact After
-
sales Service.
Err06
Water pump-out anomaly
(water remains in the dishwasher)
Check that the filters are clean, and that the drain pipe is
not bent, obstructed, narrowed.
Check that the drain pump is not blocked with a foreign
body, follow steps indicated in “10.2 Periodical checks”.
If the problem still occurs,
contact After
-
sales Ser
vice.
Err09
Excessive water level in the tank anomaly
Contact After
-
sales Service
Err23 Boiler heating anomaly (does not heat) Contact After-sales Service
Err24 Boiler temperature probe anomaly Contact After-sales Service
Err25
Boiler water filling anomaly
Check that the water supply tap is open, the dynamic
supply pressure, cleanliness of the inlet water filter. If the
problem still occurs,
contact After
-
sales Service.
Err26
Boiler emptying anomaly
Check that the nozzles of the rinsing spray arms are not
clogged.
If the problem still occurs,
contact After
-
sales Service.
Err27 Boiler emptying anomaly – with full tank Contact After-sales Service
Err28
Boiler heating anomaly (over temperature)
Contact After
-
sales Service
19.390.6882.00 20/07/2017
Rev. Manuale Data