To Next Page
J
Jessica AndersonSep 23, 2025
How to start a Smeg WHT914LSUK Washer program after closing the door?
- WwilliamsjohnSep 23, 2025
To start a program on your Smeg Washer after closing the door, press the Start / Pause / Cancel button.
How to start a Smeg WHT914LSUK Washer program after closing the door?
To start a program on your Smeg Washer after closing the door, press the Start / Pause / Cancel button.
How to open a Smeg WHT914LSUK door that is stuck?
If the loading door of your Smeg Washer cannot be opened, it could be due to a few reasons. The door lock might be activated because of the water level, in which case you should drain the water by running the Pump or Spin program. The machine might be heating water or at the spinning cycle, so wait until the program completes. Alternatively, the child lock may be engaged, so wait a couple of minutes for the door lock to deactivate after the program ends.
Why won't my Smeg WHT914LSUK go to the spinning step?
If your Smeg Washer isn't switching to the spinning step, there might be an unbalanced load in the machine, which activates the automatic unbalanced load detection system due to uneven laundry distribution. The machine also won't spin if water isn't completely drained, so check the filter and draining hose. Excessive foam from too much detergent can also prevent spinning, so use the recommended amount of detergent.
Why is my Smeg Washer vibrating so much?
Your Smeg Washer may be vibrating or making noise due to several reasons: the machine might be unbalanced, so you should adjust the feet to level it. A hard substance might be in the pump filter, so you should clean it. The transportation safety bolts may not be removed, so remove them. The laundry quantity might be too little, so add more laundry. The machine might be overloaded, so take out some laundry or distribute it evenly. Finally, the machine might be leaning on a rigid item, so ensure it's not leaning on anything.
Why my Smeg WHT914LSUK is not filling with water?
If your Smeg Washer isn't filling with water, check these things: the tap may be turned off, so turn it on. The water inlet hose may be bent, so flatten it. The water inlet filter may be clogged, so clean it. The loading door may be open, so close it.
What to do if foam is overflowing from the Smeg Washer detergent drawer?
If foam is overflowing from the detergent drawer of your Smeg Washer, mix 1 tablespoonful of softener with ½ liter of water and pour it into the main wash compartment of the detergent drawer. Also, put detergent into the machine suitable for the programs and maximum loads indicated in the "Programme and consumption table". Reduce the amount of detergent when using additional chemicals like stain removers or bleach.
Why is my laundry stiff after washing in my Smeg WHT914LSUK Washer?
If your laundry becomes stiff after washing in your Smeg Washer, it may be due to using an insufficient amount of detergent for the water hardness. Use an appropriate amount according to the water hardness. Also, make sure you are putting the detergent in the correct compartment. Avoid mixing softener with detergent and wash the dispenser with hot water.
Why doesn't my laundry smell like softener after using my Smeg WHT914LSUK?
If your laundry doesn't smell like softener after washing in your Smeg Washer, it might be because the detergent is put in the wrong compartment. If detergent is put in the prewash compartment although a prewash cycle isn't selected, the machine can take this detergent during rinsing or the softener step. Wash and clean the dispenser with hot water and put the detergent in the correct compartment. Also, do not mix the softener with detergent, and wash and clean the dispenser with hot water.
Why is there detergent residue in my Smeg WHT914LSUK Washer detergent drawer?
Detergent residue in the drawer of your Smeg Washer can occur if the drawer is wet when you add detergent, so dry it first. It can also happen if the detergent has gotten damp, so keep detergents closed in a dry environment and avoid high temperatures. Low water pressure can also contribute, so check it. The holes of the detergent compartment may be blocked, so check and clean them. There may be a problem with the detergent drawer valves, in which case, call the Authorized Service Agent. Avoid mixing softener with detergent, and wash the dispenser with hot water. Regular drum cleaning is also important.
Why isn't the programme time counting down on my Smeg WHT914LSUK?
If the program time isn't counting down on your Smeg Washer, the timer may stop during water intake until the machine takes in enough water. It may also stop during heating until the selected temperature is reached. Additionally, it can halt during spinning if the automatic unbalanced load detection system is activated due to uneven laundry distribution.
General
