EasyManua.ls Logo

Smeg WHT914LUK1 - User Manual

Smeg WHT914LUK1
28 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
2820527985_EN/ 07-11-19.(10:13)Document Number
WHT914LUK1
Washing Machine
User’s Manual

Table of Contents

Questions and Answers

  • M
    maxwellcherylSep 23, 2025
    What to do if foam is overflowing from the Smeg WHT914LUK1 detergent drawer?
    • J
      johnaverySep 23, 2025
      If foam is overflowing from the detergent drawer of your Smeg washer, it's likely due to using too much detergent. Mix 1 tablespoon of softener with ½ liter of water and pour it into the main wash compartment of the detergent drawer. Also, make sure you put the detergent into the machine suitable for the programmes and maximum loads indicated in the 'Programme and consumption table'. If you use additional chemicals (stain removers, bleaches, etc.), reduce the amount of detergent.
  • M
    mhermanAug 23, 2025
    How to open a stuck Smeg Washer door?
    • J
      Jessica StevensAug 23, 2025
      If the loading door of your Smeg washer won't open, it could be due to a few reasons. The door lock might be activated because of the water level; if so, drain the water by running the Pump or Spin program. If the machine is heating or spinning, wait until the program finishes. If the child lock is on, wait a couple of minutes after the program ends for it to deactivate. The door may also be stuck due to pressure, so try pushing and pulling the door while grabbing the handle.
  • D
    Douglas AguilarAug 25, 2025
    Why is my Smeg Washer not spinning?
    • M
      Manuel JordanAug 26, 2025
      Your Smeg washer might not switch to the spinning step if there's an unbalanced load. The automatic load detection system may activate if laundry isn't distributed evenly in the drum. Also, the machine won't spin if the water hasn't drained completely, so check the filter and drain hose. Excessive foam from too much detergent can also prevent spinning.
  • J
    Jennifer HowardAug 27, 2025
    Why is my Smeg Washer taking longer than usual?
    • R
      Robert AndersonAug 27, 2025
      Several factors can cause a Smeg washer to take longer than expected. Low water pressure makes the machine wait until it has enough water, extending wash time. Low voltage prolongs washing to compensate. Cold water requires more time to heat. The machine may increase rinse water or add an extra rinse if needed. Excessive foam from too much detergent can also extend the cycle, as can the timer stopping during water intake or heating.
  • S
    sharonsmithAug 27, 2025
    What to do if my Smeg WHT914LUK1 Washer smells bad?
    • H
      harperjonathanAug 27, 2025
      Unpleasant smells in your Smeg washer are often due to odors and bacteria that form on the drum from washing at low temperatures or using short programs. To prevent this, leave the detergent drawer and loading door slightly open after each wash. This helps prevent a humid environment where bacteria can thrive.
  • U
    uhenrySep 18, 2025
    Why is laundry stiff after washing in my Smeg Washer?
    • A
      Ashley UnderwoodSep 18, 2025
      Laundry can become stiff after washing in your Smeg washer if you're not using enough detergent for the water hardness. Also, make sure that you are putting detergent in the correct compartment and that detergent is not mixed with the softener.
  • H
    Howard JacobsSep 15, 2025
    Why is there too much foam in my Smeg Washer?
    • M
      Monica BaileySep 15, 2025
      Excessive foam in your Smeg washer can be caused by using the wrong type of detergent, using too much detergent, or storing detergent improperly. Use detergents designed for washing machines and use only the necessary amount. Store detergent in a closed, dry location, away from heat. Also, some meshed laundry items may create too much foam. Check that you're putting the detergent in the correct compartment.
  • M
    Melanie RobinsonSep 16, 2025
    How to fix Smeg WHT914LUK1 that does not rinse well?
    • J
      johnsonnathanSep 16, 2025
      If your Smeg washer isn't rinsing well, the issue might be with the detergent's amount, brand, or storage. Use a detergent suitable for washing machines and your laundry, and store it properly. Ensure detergent is placed in the correct compartment. Also, check if the pump filter or drain hose is blocked.
  • J
    jonesmichaelSep 6, 2025
    Why is my Smeg Washer programme time not counting down?
    • J
      Julian MoraSep 6, 2025
      If the program time isn't counting down on your Smeg washer, it could be due to an unbalanced load. The automatic unbalanced load detection system may activate if the laundry isn't distributed evenly in the drum.
  • J
    Jonathan DavisSep 3, 2025
    Why is my Smeg Washer laundry turning gray?
    • K
      Katherine GonzalezSep 4, 2025
      Laundry turning gray in your Smeg washer can be caused by using too little detergent over time, washing at low temperatures for too long, or using too little detergent with hard water. Always use the recommended amount of detergent for your water hardness and laundry type. Once graying occurs, it's difficult to reverse.

Smeg WHT914LUK1 Specifications

General IconGeneral
TypeFreestanding
Loading typeFront load
Load Capacity9 kg
Energy RatingA+++
Spin Speed1400 rpm
ColorWhite
Energy efficiency classA+++
Weight73 kg
Delay StartYes
Child LockYes
Drum MaterialStainless steel

Related product manuals